كود اردوينو حساس الحركة arduino code pir motion sensor
-
2019-06-30
- | AliaMz
- | مشاهدات: 9268
كود اردوينو حساس الحركة arduino code pir motion sensor
/*
* PIR sensor tester
*/
int ledPin = 7; // choose the pin for the LED
int inputPin = 8; // choose the input pin (for PIR sensor)
int pirState = LOW; // we start, assuming no motion detected
int val = 0; // variable for reading the pin status
void setup() {
pinMode(ledPin, OUTPUT); // declare LED as output
pinMode(inputPin, INPUT); // declare sensor as input
Serial.begin(9600);
}
void loop(){
val = digitalRead(inputPin); // read input value
if (val == HIGH) { // check if the input is HIGH
digitalWrite(ledPin, HIGH); // turn LED ON
if (pirState == LOW) {
// we have just turned on
Serial.println("Motion detected!");
// We only want to print on the output change, not state
pirState = HIGH;
}
} else {
digitalWrite(ledPin, LOW); // turn LED OFF
if (pirState == HIGH){
// we have just turned of
Serial.println("Motion ended!");
// We only want to print on the output change, not state
pirState = LOW;
}
}
delay(1000);
}
هذه المادة الدراسية هي ضمن مكتبة
مكتبة اكواد اردوينو arduino جاهزةقد يهمك أيضاً بمادة
التعليقات
لا يوجد تعليقات
لاضافة سؤال او تعليق على المشاركة يتوجب عليك تسجيل الدخول
تسجيل الدخول
تسجيل الدخول